Knowledgebase
KTEC Group Support Helpdesk > KTEC Group Help Desk > Knowledgebase

Search help:


FX1200e is struggling to detect the reg mark

Solution

If the FX1200 cutter is struggling to detect the reg mark, you can expand the white area around it by simply 

placing some label material on the bottom edge (away from the roller) and slightly under the linear.

 

This make it easier for the sensor to detect the mark.

 

See attachment for instructions

Attachments:
Label-stuck-underneath-the-liner.jpg Label-stuck-underneath-the-liner.jpg

 
Was this article helpful? yes / no
Related articles How to manually install the printer driver
What are the FX1200 cut file specifications including target mark size and position?
The target mark is printing too close to the edge of the label stock (CX1200).
What are the PTFinish Advanced Tab Settings used for? (FX1200)
Article details
Article ID: 118
Category: Primera CX1200
Date added: 2019-02-13 17:54:40
Views: 25
Rating (Votes): Article rated 3.0/5.0 (2)

 
« Go back

 
Powered by Help Desk Software HESK, brought to you by SysAid